my diswasher works when it wants to. - Appliance Repair Forum - Free Service from Appliance Parts Pros

Welcome Guest! You can not login or register.

Notification

Error

my diswasher works when it wants to. Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: MDBTT60AWB	Brand: Maytag	Age: 1 - 5 years
Previous Topic Next Topic

05swatts		#1 Posted : Sunday, May 27, 2012 12:28:40 PM(UTC)
Rank: Member Groups: Registered Joined: 5/27/2012(UTC) Posts: 2		Please help. mY DISWASHER WORKS WHEN IT WANTS TO. I CAN PUSH ANY BUTTON AND THEY WILL LIGHT UP SOMETIMES & SOMETIMES THEY WONT LIGHT UP. IF THEY DO LIGHT UP AND I PUSH START NOTHING HAPPENS. I HAVE TO GO DAYS WITHOUT IT WORKING AND THAN ALL OF A SUDDEN I'LL TRY AGAIN AND IT WORKS. BUT IT WILL ONLY WORK FOR ONE LOAD. IF I UNLOAD IT WHEN IT'S DONE AND RELOAD IT TO WASH AGAIN IT WONT WORK. HELP PLEASE..I HAVE TRIED TURNING BREAKER OFF FOR A FEW HOURS, LEAVING THE DOOR OPEN OVERNIGHT. NOTHING SEEMS TO WORK


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

denman		#2 Posted : Wednesday, May 30, 2012 1:20:55 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 2/29/2008(UTC) Posts: 19,638 Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)		Here are your parts Replacement parts for Maytag MDBTT60AWB DISHWASHER- UNDERCOUNTER \| AppliancePartsPros.com Please turn your cap lock off. No one likes being yelled at. Connector Cleaning / Checking Unplug the unit Open it up Remove the ribbon cable from the keypad to the control board at the control board. Clean the edge connector. If it is the type where there is not a connector just the insulation is removed, it can be cleaned with a pencil eraser. Do not use an ink eraser as it is too abrasive. Check the tracks in the ribbon cable for hairline cracks. A magnifying glass helps here. Would not hurt to clean the connector on the board. Use electronics contact cleaner or isopropyl alcohol and a tooth brush. Be gentle and do not reconnect till all the solvent evaporates. Reconnect everything and give it a try. Remove power from the unit when working on it. If the unit is connected to the line by wire nuts. Remove them and then re-install to be sure that they are OK. Check that the door switches close could be one of them is just on the edge of closing.
		THIS FORUM IS DEAD!!!!!!!


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest (3)

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close