I installed the door gasket on a Hot Point refrigerator Model#CTF15EBC and this is my problem. The bottom of the refrigerator door closes correctly, meaning that it touches the refrigerator, but the top of the refrigerator door does not. It is about an inch away from the refrigerator body. It looks like the door became warped as a result of installing the gasket. How is this possible?
The gasket is held in place by the same screws that hold the inside door frame to the door. Is there a sequence of tightening the screws which could warp the door if not done correctly? :confused:

Yes, I removed all the screws again and then screwed in the one screw on each side which looked like they were the alignment screws because they were the only two screw holes on the sides (NOT COUNTING THE corner screws) where the holes are the exact size of the screws so that an exact fit is necessary to secure the bracket to the inside door frame that is secured to the outside door cover. Once that was accomplished the rest of the screws went in fairly easily.