GE washer motor will not run - Appliance Repair Forum - Free Service from Appliance Parts Pros

Welcome Guest! You can not login or register.

Notification

Error

GE washer motor will not run Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: WJRR4170GOWW	Brand: GE	Age: Less than 1 year
Previous Topic Next Topic

richappy		#1 Posted : Thursday, December 27, 2007 7:47:50 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 9/10/2007(UTC) Posts: 9,586 Was thanked: 2 time(s) in 2 post(s)		Washer motor will not run on any cycle, schematic is incomplete, shows no motor or timer, wires go to motor and timer but just stop!! Suspect internal motor thermal fuse. One data base shows parts, but no motor!


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

TechnicianBrian		#2 Posted : Thursday, December 27, 2007 9:46:58 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 12/2/2007(UTC) Posts: 769		There is no thermal fuse on that motor, and if you show voltage to the motor, you will need to replace the whole thing WH20X10035. One thing to try is follow the wire harness up the right side until it gets bundled together with heat shrink. Inside you will find an in-line thermal fuse on the neutral line to the motor. See if it's open. I am about 50/50 on replacing motors or fuses.


User Profile View All Posts by User View Thanks

Gene		#3 Posted : Thursday, December 27, 2007 10:21:04 AM(UTC)
Rank: Advanced Member Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455 Was thanked: 4 time(s) in 4 post(s)		Hi Richappy This is a new GE Profile washer with a new variable speed inverter/motor assembly. The motor status is displayed through a series of flash codes from a green LED located on the front side of the inverter just above the motor. It has the inline fuse (in the lid switch harness) which disables the motor. It also has a shaft and mode shifter assembly instead of a transmission. It suppose to be a mini-manual inside the control panel. Happy New year! Gene.


User Profile View All Posts by User View Thanks

richappy		#4 Posted : Thursday, December 27, 2007 1:36:06 PM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 9/10/2007(UTC) Posts: 9,586 Was thanked: 2 time(s) in 2 post(s)		Thanks Gene and TechnicianBrian: Fuse was good, motor open. Never saw a schematic so screwed up, like they fired the draftsman before he could complete it!! Happy New year to you both, will be watching the Penn. State, Texas A&M bowl game Saturday


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close