Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error
5 Pages«<345
Kenmore doesn't clean-"Clean " Flashning Seven times
Options
Go to last post Go to first unread
Model: 165-14200 Brand: Sears Age: 1 - 5 years
Previous Topic Next Topic
Neal  
#41 Posted : Wednesday, January 9, 2008 1:00:56 AM(UTC)
Neal

Rank: Member

Groups: Registered
Joined: 12/27/2007(UTC)
Posts: 21
No I didn't. I check everything at the control board, The back off the connector.
Back to top
Neal  
#42 Posted : Thursday, January 10, 2008 1:44:36 AM(UTC)
Neal

Rank: Member

Groups: Registered
Joined: 12/27/2007(UTC)
Posts: 21
Thanks you everyones input. I'm not going to fix it. Tired of fooling with it after 3 weeks. I'm going to replace the unit with another one. Thanks
Back to top
Tyro  
#43 Posted : Sunday, January 27, 2008 6:55:01 PM(UTC)
Tyro

Rank: Member

Groups: Registered
Joined: 1/27/2008(UTC)
Posts: 1
I have a Kenmore model 66517019400. I assume the seven "clean" blinks mean the same thing on my model as the others. I tried pushing the buttons that more closely matched the one suggested earlier, but without luck. What buttons should I push on my model? Thanks.
Back to top
richappy  
#44 Posted : Monday, January 28, 2008 2:41:22 AM(UTC)
richappy

Rank: Advanced Member

Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586

Was thanked: 2 time(s) in 2 post(s)
You have to reset the computer. Pull your service sheet, procedure should be in there. If not do the following.
Open door and within 3 seconds, press the hi temp. scrub, then energy saver buttons, then repeat. Close and latch door and hit the cancel button, should reset.
The cause of this is low water temperature, or a bad heater circuit.
Back to top
hpmem  
#45 Posted : Monday, March 10, 2008 12:17:41 PM(UTC)
hpmem

Rank: Member

Groups: Registered
Joined: 3/10/2008(UTC)
Posts: 1
I have the Model 665.1602 I reset the CLEAN flashing light by using the sugestion this forum it said to:
Try Pressing:
Normal Wash - HeatedDry -Normal Wash &#8211; HeatedDry- Normal Wash &#8211; HeatedDry- Normal Wash - HeatedDry[/font] . all the lights should come on. then after a little bit. keep pressing start till disher washer gets back to normal shut down. what happen your water was to cold going into the disherwasher one time taking to long to warm up. the dishwaher went into a fault mode. the light blinks 7 times because there was a fault with your heater circuit. this should take care of it.
Back to top
Users browsing this topic
Guest (9)
5 Pages«<345
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Privacy Policy | Powered by YAF.NET | YAF.NET © 2003-2024, Yet Another Forum.NET