Rank: Member
Groups: Registered
Joined: 4/21/2009(UTC) Posts: 2
|
dishwasher doesnt clean good. seems not enough pressure to spin upper arm. if i open door during wash cycle, lower arm was spinning but upper arm doesn't move and water just trickles out of it. have cleaned pump screens. suggestions appreciated.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Have you cleaned the pump filter and the rinse arm assembly (#6 & #7 on the diagram)? Gene.
|
|
|
|
Rank: Member
Groups: Registered
Joined: 4/21/2009(UTC) Posts: 2
|
Yes, thanks. I have removed and cleaned 6 & 7 and inspected the pump impeller. There was a little lime on them. Cleaned them but the top spray arm still doesn't spin. Is there anything in the hose (valve etc) between the pump and the top spray arm that could be goofed up? I haven't pulled the unit from under the counter to physically check the hose.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
There is nothing in the upper spray arm hose. Check the water level. Make sure the upper spray arm is completely open and check the hose.
Gene.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close