replaced control panel now normal light flashes - Appliance Repair Forum

Welcome Guest! You can not login or register.

Notification

Error

replaced control panel now normal light flashes Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: GU1500XTLQ1	Brand: Whirlpool	Age: 1 - 5 years
Previous Topic Next Topic

moovrs		#1 Posted : Monday, April 20, 2009 3:31:54 PM(UTC)
Rank: Member Groups: Registered Joined: 4/20/2009(UTC) Posts: 2		Help - the lock button was stuck on and I was told to replace the control board. I just replaed the control board and now the normal light flashes and it runs for a minute and stops full of water. what now?


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

denman		#2 Posted : Tuesday, April 21, 2009 5:12:04 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 2/29/2008(UTC) Posts: 19,638 Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)		Here are your parts Replacement parts for WHIRLPOOL GU1500XTLQ1 \| AppliancePartsPros.com Here is a service manual and a tech sheet https://secured.whirlpoo...520548/$FILE/8178022.pdf https://www.servicematters.com/d...0Sheet%20-%208537797.pdf The above should help you diagnose the problem. Try different cycle types re: where it does not look at the water temperature, as it may be waiting for the temp to rise tos certain level.
		THIS FORUM IS DEAD!!!!!!!


User Profile View All Posts by User View Thanks

moovrs		#3 Posted : Wednesday, April 22, 2009 5:01:47 AM(UTC)
Rank: Member Groups: Registered Joined: 4/20/2009(UTC) Posts: 2		Thanks for the repair manual - it is helpful. The water is not getting hot. Not sure what to check next.


User Profile View All Posts by User View Thanks

denman		#4 Posted : Wednesday, April 22, 2009 5:54:12 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 2/29/2008(UTC) Posts: 19,638 Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)		I would check the heater with a meter to see if it has continuity. Should b3 10 to 35 ohms. If OK Check the HiLimit thermostat, should be 0 ohms If OK Check that the heater is getting voltage when it should (120 volts)
		THIS FORUM IS DEAD!!!!!!!


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close