Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error

Options
Go to last post Go to first unread
jtagscott  
#1 Posted : Wednesday, November 28, 2007 8:18:49 PM(UTC)
jtagscott

Rank: Member

Groups: Registered
Joined: 11/28/2007(UTC)
Posts: 3

Dryer was only warm and took 2 to 3 cycles to dry.
Replaced the heating element and it worked great for 3 loads then that completely quit heating. Everything else seems to work fine.
Any suggestions?
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com
 
Gene  
#2 Posted : Wednesday, November 28, 2007 8:39:58 PM(UTC)
Gene

Rank: Advanced Member

Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455

Was thanked: 4 time(s) in 4 post(s)
Most likely the problem is a clogged vent inside walls which caused the moister to stay inside the dryer and overheat to the dryer.

If it's not heating at all, probably the thermal cut off on the heater box is blown.

- The part number for the thermal cut off kit AP3094224

Gene.
jtagscott  
#3 Posted : Wednesday, November 28, 2007 9:16:48 PM(UTC)
jtagscott

Rank: Member

Groups: Registered
Joined: 11/28/2007(UTC)
Posts: 3

Thanks so much. I seen those parts back there but wasn't sure what they were. That sounds like that's the fix.
Thanks again.

Jim
jtagscott  
#4 Posted : Tuesday, December 11, 2007 12:18:27 PM(UTC)
jtagscott

Rank: Member

Groups: Registered
Joined: 11/28/2007(UTC)
Posts: 3

I ordered and replaced the thermal cut off kit, but still no heat.
You also were right about the clog inside. I cleaned that out as well.
Is there a way to check if the cut offs are still good? Or is there any other fuse or shut off it could be?
Gene  
#5 Posted : Tuesday, December 11, 2007 12:36:51 PM(UTC)
Gene

Rank: Advanced Member

Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455

Was thanked: 4 time(s) in 4 post(s)
I would recommend to perform the troubleshooting according to the heat circuit from the wiring diagram and the break down diagrams for your dryer.

If the thermal cut off is blown - it should be open.

Gene.
Users browsing this topic
Guest (2)
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.