Customer Support 7 days a week

Welcome Guest! To enable all features please Login or Register.

Notification

Icon
Error

Options
Go to last post Go to first unread
eriewhaler  
#1 Posted : Monday, July 25, 2011 5:42:29 PM(UTC)
eriewhaler

Rank: Member

Groups: Registered
Joined: 7/25/2011(UTC)
Posts: 1

To All:

I have a Kitchen Aid dishwasher in which I can run the diagnostic and it goes through all the cycles. However, it does not start a normal cycle. Is this a problem with the control panel , electronic control assembly, or something else?

Thanks
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com
 
Jeff / APP Team  
#2 Posted : Tuesday, July 26, 2011 7:29:19 AM(UTC)
Jeff / APP Team

Rank: Advanced Member

Groups: Moderators
Joined: 2/14/2011(UTC)
Posts: 816

Hello eriewhaler. Remove the ribbon cable from the control board. With the positive lead on your meter, check pin 1-12, and with the negative lead, check pin 1-5. When you push the start button, these contacts should go from infinity down to an ohm reading. If so, the start button on the panel is working properly. If not, you will need to replace the user interface. If the control panel is working properly, check and make sure the door switches are good. If so, you will need to replace the control board. You can test this with a multi-meter [AP3873826]. Here is a link on how to use a multi-meter. Hope this helps.http://forum.appliancepartspros...continuity-ohmmeter.html

Part number: AP3177796
Users browsing this topic
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.