Rank: Member
Groups: Registered
Joined: 2/21/2011(UTC) Posts: 2
|
Dishes not getting clean, residue getting "baked on" during dry cycle Water not getting hot during wash cycle (used to be steaming hot if washer was opened during wash cycle). Now, water is luke-warm (measured with thermometer at 90 degrees). However, heating element is good, works great during dry cycle (dishes are very warm to the touch)
Any thoughts? Has the control board gone bad?
A wiring diagram and/or schematic would be most helpful. As would a parts catalog with parts diagrams
Thanks in advance
wiz
|
|
|
|
Rank: Advanced Member
Groups: Moderators
Joined: 2/14/2011(UTC) Posts: 816
|
Did you test the thermostat under the bottom as well. Here is the part number with picture of it, as well as a link to the parts diagrams for your dishwasher. Hope this helps. Part number: AP3010530
|
|
|
|
Rank: Member
Groups: Registered
Joined: 2/21/2011(UTC) Posts: 2
|
Where can I find the thermostat? Is it near the motor? Do I have to pull the dishwasher out to get to it? Do you maybe have a link to a wiring diagram?
tks wiz
|
|
|
|
Rank: Advanced Member
Groups: Moderators
Joined: 2/14/2011(UTC) Posts: 816
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close