Rank: Member
Groups: Registered
Joined: 12/16/2008(UTC) Posts: 2
|
I have a Whirlpool microwave where some of the touchpads (not all) on the flat panel stopped working. I was able to find the correct replacement part.
Does anyone have instructions for removing the old panel so that I can replace it.
Thanks in advance.
Rocky
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Hi Rocky, Remove the two screws on top of the microwave secured the top grill. Pull the grill out. Remove the screw on top of the control panel and remove the control panel. Unplug the touch pad ribbon from the control board. Remove the screws holding the control board to the panel and remove the control board. Push out the tabs on the panel holding the mounting plate and remove the plate. Assemble everything in the reversed order. Here are the break down diagrams for the Whirlpool microwave Model MH3184XPB3Gene.
|
|
|
|
Rank: Member
Groups: Registered
Joined: 12/16/2008(UTC) Posts: 2
|
Gene, Thanks for the info. I'll give it my best shot. Rocky
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close