Rank: Member
Groups: Registered
Joined: 11/28/2008(UTC)
Posts: 2
|
Dishwasher display went blank during 1st fill. Breaker not tripped. Checked two latch micro-switches and fuse on control board, all ok. Replaced the control board, pushed buttons for quick rinse (dw was still full of water from previous failed cycle) display lit up, heard the fill start & about 30 seconds later display went dead again before starting the wash cycle. I hope I didn't just blow a $100 board. No burned spots on the back of the board. Any advise on how to proceed?
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 5/28/2008(UTC)
Posts: 1,620
|
Check the junction box under the washer where the house wiring is connected to the dishwasher. You may have a bad power or nuetral connection.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 11/28/2008(UTC)
Posts: 2
|
Junction wiring checks OK.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 6/25/2008(UTC)
Posts: 5
|
Please keep me posted on your progress. I'm in the same boat. I changed the board as well ($100.00) and nothing. After playing around with it a bit it started again. Went through one cleaning complete. Next load stopped mid cycle, thing full of water, no lights, nothing.
HELP!!!
:mad: Skip:mad:
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
