Rank: Member
Groups: Registered
Joined: 12/23/2010(UTC)
Posts: 1
|
My whirlpool duet washer bellow (boot) won't stay in place. It was replaced due to a tear a few days ago and we installed a new one. Did not try to overtighten the clamp first time. Second time we tightened the clamp down. It did a few loads and then came off again. HELP I am pretty good at home repairs but?? Any suggestions?
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 12/24/2010(UTC)
Posts: 3
|
Originally Posted by: IMwrestler  My whirlpool duet washer bellow (boot) won't stay in place. It was replaced due to a tear a few days ago and we installed a new one. Did not try to overtighten the clamp first time. Second time we tightened the clamp down. It did a few loads and then came off again. HELP I am pretty good at home repairs but?? Any suggestions?
Make shore the clamp is in the grove around the drum push
the boot down in the grove make shore it is tight all the way around then put
your clamp on. If the clamp loosens up get a new one.
Joe
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
