Rank: Member
Groups: Registered
Joined: 12/11/2010(UTC)
Posts: 3
|
I had to replace the motor switch #2-05131 and do not know how to rewire to the motor and washer. I thought I had it right, but when I operate the washer it only agatates and will not go into spin cycle, during spin it only agatates. I beleive it is supose to reverse the motor to allow the transmission to go into spin, but am not sure. Please help!!!
Lee
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 3/29/2009(UTC)
Posts: 11,699
|
There should have been a set of instructions with the switch, these here Part number: AP4023837
If you do not have them, contact the place that sold you the switch.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
There is a schematic shown in this sites break down info, just click on your model #, schematic shows which wires go were.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
