Rank: Member
Groups: Registered
Joined: 11/13/2008(UTC)
Posts: 6
|
I have a kenmore 110.92293100 that is over 10 yrs old. When I do a hot water wash the water trickles into the machine, making the wash time extremely long.. cold water washing is fine, and the hot water feed is good. Thoughts anyone? Dan C
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 8/13/2008(UTC)
Posts: 3,097
|
Most likely the valve isn't opening properly, try replacing the valve part #AP3096174
Nat
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 2/29/2008(UTC)
Posts: 19,638
Thanks: 1 times
Was thanked: 11 time(s) in 11 post(s)
|
Remove the hot water hose and check the screen filter on the input side of the machine's water inlet valve. It could be partially plugged.
If it is dirty, clean it. Do not remove it as it is there to keep crud out of the valve which could hold the valve open causing a flood.
Also, if it is clogged would be a good idea to drain some water out of your hot water tank. Use the drain at the bottom or the pressure release valve. Let it run till it is clear. |
THIS FORUM IS DEAD!!!!!!! |
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
