Frigidaire FDBB945DC1 Display Cycles But Pumps Don't Run - Appliance Repair Forum

Welcome Guest! You can not login or register.

Notification

Error

Frigidaire FDBB945DC1 Display Cycles But Pumps Don't Run Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: FDBB945DC1	Brand: Frigidaire	Age: 5 - 10 years
Previous Topic Next Topic

cablebreak		#1 Posted : Saturday, November 6, 2010 12:17:04 PM(UTC)
Rank: Member Groups: Registered Joined: 11/6/2010(UTC) Posts: 1		Frigidaire FDBB945DC1. Control panel LEDs work. Any cycle can be selected and started. However when the cycle is started I hear a relay click but no motors come on. As the wash cycle continues on the display there is a click when it changes from washing to drying, etc. But the motor(s) never come on to run the pumps. If the Wash/Cancel button is pushed the cycle stops but water isn't pumped out. Again no pump or motor noise is heard. The water level valve isn't stuck and moves freely. Also the switch attached to it clicks when raised and lowered.


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

denman		#2 Posted : Tuesday, November 9, 2010 5:14:11 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 2/29/2008(UTC) Posts: 19,638 Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)		Here are your parts Replacement parts for FRIGIDAIRE FDBB945DC1 Frigidaire/dishwasher \| AppliancePartsPros.com Here is the tech sheet http://manuals.frigidaire.com/prodinfo_pdf/Kinston/154459001.pdf Note: The water level switch should not effect the drain pump. You could try the self test. If you can get the motors to run then odds are the control board is toast. If the motors do not run it does not rule out the control board. Since neither the main pump or the drain motor run, the control board would be at the top of my list. I would check that the wires from the control board to the motors are OK especially the wire that is common to them both. I would also check the control board for signs of overheating, track cracks or bad connections.
		THIS FORUM IS DEAD!!!!!!!


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close