No water flow at any point. I ran the self diagnostic test and it shows everything good. I ran the manual test and activated the water valve, but still no water. I was afraid of a stuck valve, so I went ahead and replaced it, to no avail. Continuity tests good on the float switch. If I disconnect the wires to the water inlet valve and connect a meter, I never get voltage though any of the cycles. If I touch a lead to either side of the valve or switch, and the other lead to ground, I show 116vac at all times, even if shut off. So that tells me that the door switch is good and is supplying 116vac to the valve and through the float switch and back to the control board, waiting on the cntl board to supply a ground to complete the circuit.?. Am I correct in that thought? Leading me to believe a bad control board?

Lol Yes it is, I guess I should have clarified that there's good water flow all the way to the inlet valve.