Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error

Options
Go to last post Go to first unread
douggray  
#1 Posted : Thursday, September 9, 2010 5:31:59 PM(UTC)
douggray

Rank: Member

Groups: Registered
Joined: 9/9/2010(UTC)
Posts: 1

When doing a load of laundry the machine beeps several times and displays the error code F 06. The motor is not hot and following the directions in the manual: Cancel and then Start causes the machine to add additional water and does not spin out any of the water in the tub. The machine beeps again, displays the same message and we are back where we started.

Is this a problem with the motor control? (solid state board) #AP3861856
Or is the tachometer the problem? Does the motor have to be changed?
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com
 
Joe / APP Team  
#2 Posted : Friday, September 10, 2010 8:42:23 AM(UTC)
Joe / APP Team

Rank: Advanced Member

Groups: Moderators
Joined: 7/14/2010(UTC)
Posts: 5,222

Was thanked: 1 time(s) in 1 post(s)
Originally Posted by: douggray Go to Quoted Post
When doing a load of laundry the machine beeps several times and displays the error code F 06. The motor is not hot and following the directions in the manual: Cancel and then Start causes the machine to add additional water and does not spin out any of the water in the tub. The machine beeps again, displays the same message and we are back where we started.

Is this a problem with the motor control? (solid state board) #AP3861856
Or is the tachometer the problem? Does the motor have to be changed?


Doug,

Very seldom, the F06 code is a bad motor.

If you have a meter, the winding resistance should be approximately 6 ohms resistance pin 1 to pin 2, pin 1 to pin 3 and pin 2 to pin 3.

Pin 4 to pin 5 should read approximately 250 ohms

As long as your motor windings test have the same resistance,and the tach circuit has 250 ohms, your motor is OK.

And you need to start looking for loose wires in the harness from the motor control board to the central control board, no loose wires would indicate a bad motor control board

Part number: AP3861856
Part number: AP3861856


Good Luck,
:cool: :) :cool:
Users browsing this topic
Guest (3)
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.