Rank: Member
Groups: Registered
Joined: 10/9/2022(UTC) Posts: 0  Location: Maryland
|
Sani-rinse started blinking at end of cycle. Diagnostic mode gave me F3E3 and F9E1 errors. Replaced diverter motor and OWI Sensor. Ensured incoming water is 125. Ran our normal cycle to calibrate. (Normal, sani-rinse, heat dry) and sani-rinse still blinking. Ran complete diagnostic cycle again and returned no errors. Tried full was cycle and sani-rinse is blinking. Any ideas what could still be causing the sani cycle to register incomplete?
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
