Rank: Member
Groups: Registered
Joined: 10/18/2016(UTC)
Posts: 3
|
OK have a Electrolux IQ front load washer. Got error code E38.
Replaced Pressure switch
Cleared stored codes.
E00- No Errors
Start a wash cycle and just get two beeps and nothing happens.
Go into diagnostic mode. Test all 11 steps/cycles. They all pass. At the end of the diagnostic check error codes. Still E00 (no errors)
Start a normal wash cycle and get just 2 beeps and nothing happens.
What do you guys think? Very hard to diagnose when there is no error codes. I'm stumped.
Thanks in advance for any and all help!
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 10/18/2016(UTC)
Posts: 3
|
During Installation Cycle It seems to stay stuck at 2mins and not advance.
Finally went to 1 min and filled and spinned (this was after about 6mins actual time)
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 10/18/2016(UTC)
Posts: 3
|
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
