Rank: Member
Groups: Registered
Joined: 2/13/2012(UTC)
Posts: 5
|
Our 6 yr old Kitchenaid dishwasher recently stopped washing. It fills and drains fine and acts like the cycle completes but there's no washing. I ran the diagnostic cycle and tested the lead to the motor (pins 2 and 3) and there is 122V going to it during the wash intervals.
I suspect the motor is bad but I noticed on the wiring schematic that there is a motor fuse, however I can't find anything online about the motor fuse, only the thermal fuse. Are these the same thing? Also, if the motor is bad, is there any way to buy just a replacement motor without having to buy the entire sump assembly?
Thanks in advance for any help!
-Brian
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 8/14/2016(UTC)
Posts: 3
|
Brian, I am working on a unit with the same problem. When I removed the motor though, the impeller had come off the motor shaft. It wasn't broken, just unscrewed itself off. It also blew the fuse that is soldered to the back of the electronic control board. I will post what else I find later.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
