GE Monogram Dishwasher Door Bottom Splash Guard - Appliance Repair Forum

Welcome Guest! You can not login or register.

Notification

Error

GE Monogram Dishwasher Door Bottom Splash Guard Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: ZBD0710K10SS	Brand: GE	Age: 5 - 10 years
Previous Topic Next Topic

jaybeegee		#1 Posted : Tuesday, November 17, 2015 5:59:21 AM(UTC)
Rank: Member Groups: Registered Joined: 11/17/2015(UTC) Posts: 2		I have searched in vain for a simple replacement gasket for the door bottom of our GE Monogram dishwasher. Ours has a split in the middle and it is leaking. From the parts schematics, there seems to be no listing for the gasket alone. One site is telling me that the entire inner panel has to be purchased for > $200. This seems ridiculous. Can someone point me to a replacement part, or even suggest a way of repairing the gasket (i know that sounds like a bad idea).


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

denman		#2 Posted : Tuesday, November 17, 2015 6:44:41 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 2/29/2008(UTC) Posts: 19,638 Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)		Below is the part, click on the picture for more info about it. The Q&A does say that the seal is not available as a separate item. Part number: AP3794401 Looking at the picture it does seem that there is an opening in the center of the door so perhaps this is not your problem. As far as a jiggery pokery fix I cannot see the seal or how it is attached to give you a suggestion.
		THIS FORUM IS DEAD!!!!!!!


User Profile View All Posts by User View Thanks

jaybeegee		#3 Posted : Tuesday, November 17, 2015 12:16:26 PM(UTC)
Rank: Member Groups: Registered Joined: 11/17/2015(UTC) Posts: 2		Thanks for the confirmation. I too saw what might have been a gap in the gasket in the panel picture you posted. Zooming in as much as possible, i was skeptical that was a gap, but I cannot explain it otherwise. Just seems like that would be a bad design to have a split in the gasket. But our split is roughly in the middle.


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest (2)

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close