My washing machine fills with water after the final spin. It is the same if i use extra rinse or not.
I have a Maytag LAT6914AAE.

I was told to check the water pump, hose and valve.
When i unplug the machine or open the lid i stops filling, there is no drips at all, so i don't think it is a leaky valve.
When i put it on spin, it drains the water, and it goes up the hose and out the drain, so i don't think it is the water pump, hose or drain.
I'm thinking it might be the timer, but i would like some confirmation. The timer is rather expensive (~$150.00) and i not sure i want to spend that kind of money on a ~20 yr old machine.
Is there something else i should check. I opened the panel and looked for burned wires, but i only did a cursory inspection of the area, i did not follow any of the wires.

If i empty the tub and select a different water level, it stops filling at the correct level.



At PRESOAK the tub fills with water, not agitation. SOAK light stays off.
At 12 8 5 nothing happens, no agitation, SOAK light stays off.
About half-way between 5 and the first rinse, the SOAK light comes on.
None of the rinse, spin, off, spin do anything, until about a quarter inch before OFF, than it starts spinning and draining the water. Extra rinse is turned off.
When it gets almost (1/8") to OFF, it still spins, but the water starts filling up, then the tub stops spinning and the water continues to fill the tub up to the water level selected.