Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error

Options
Go to last post Go to first unread
mark090  
#1 Posted : Wednesday, December 3, 2014 8:28:26 AM(UTC)
mark090

Rank: Member

Groups: Registered
Joined: 12/3/2014(UTC)
Posts: 2

I have a Kitchen-aid, did the diagnostic test, option dryer light does not come on but can hear the beep when button is push.error codes 6-1 and 6-4 come up but they are not the issues, the dishwasher works fine but dry light never comes on and the dishes are wet. Any ideas
Thanks
Mark
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com
 
denman  
#2 Posted : Friday, December 5, 2014 4:51:03 AM(UTC)
denman

Rank: Advanced Member

Groups: Senior Expert
Joined: 2/29/2008(UTC)
Posts: 19,638

Thanks: 1 times
Was thanked: 11 time(s) in 11 post(s)
Here are your parts.

Since you know the error codes I am assuming that you have the tech sheet.

Check the heater circuit at the control board (P4-3 to P4-4), should be about 30 ohms. If it is infinite ohms or high you will have to check the hi-limit thermostat, the heater and the wires going to them.

If the above is OK I would say it is the control board as you do get a beep when you push the button.

Note that this is always a bit of a crap shoot.
THIS FORUM IS DEAD!!!!!!!
mark090  
#3 Posted : Friday, December 5, 2014 8:32:09 AM(UTC)
mark090

Rank: Member

Groups: Registered
Joined: 12/3/2014(UTC)
Posts: 2

The element checks ok, is the led on panel not lighting because of control board even though it beeps and do you know what goes bad on the control bord that can be repaired rather replace the whole board
denman  
#4 Posted : Friday, December 5, 2014 1:39:29 PM(UTC)
denman

Rank: Advanced Member

Groups: Senior Expert
Joined: 2/29/2008(UTC)
Posts: 19,638

Thanks: 1 times
Was thanked: 11 time(s) in 11 post(s)
They do not publish schematics of the boards so unless it is something visually obvious they are a replacement item.

Even the control board is a guess.
It looks like this unit has an active keypad in other words the key presses are converted to digital on the panel and then sent to the control board so it cannot be checked properly.

If you get the control board from AppliancePartsPros they will let you return it if it does not fix your problem. Please see their return policy.
THIS FORUM IS DEAD!!!!!!!
Users browsing this topic
Guest (2)
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.