Top-Load Washer Chugging at Spin Start - Appliance Repair Forum

Welcome Guest! You can not login or register.

Notification

Error

Top-Load Washer Chugging at Spin Start Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: 110.23012100	Brand: Kenmore	Age: More than 10 years
Previous Topic Next Topic

jw_elder77		#1 Posted : Tuesday, September 9, 2014 7:25:22 AM(UTC)
Rank: Member Groups: Registered Joined: 9/9/2014(UTC) Posts: 2		Yesterday our Kenmore Elite top-load washer ran fine until it got to the rinse spin cycle. The motor started "chugging" like it was starting and stopping. The tub was moving in fits and starts along with the motor chugging. I was able to get the spin cycle to start normally after "flicking" the lid switch a few times. Any suggestions what may need to be replaced, etc. are greatly appreciated. It only happened the one time, but we haven't run another load yet after this one with the problem. Thanks.


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

fairbank56		#2 Posted : Tuesday, September 9, 2014 8:52:11 AM(UTC)
Rank: Advanced Member Groups: Expert Joined: 10/16/2012(UTC) Posts: 3,806 Was thanked: 7 time(s) in 7 post(s)		Could be the lid switch, timer, motor switch or speed select switch but since you got it working by messing with the lid switch, I would start there. Did this happen before drain or after? Whirlpool 8054980 Switch, Lid - AppliancePartsPros.com Eric


User Profile View All Posts by User View Thanks

jw_elder77		#3 Posted : Tuesday, September 9, 2014 10:29:43 AM(UTC)
Rank: Member Groups: Registered Joined: 9/9/2014(UTC) Posts: 2		Thanks for the suggestions, Eric. This happened after the drain. John


User Profile View All Posts by User View Thanks

fairbank56		#4 Posted : Tuesday, September 9, 2014 2:13:37 PM(UTC)
Rank: Advanced Member Groups: Expert Joined: 10/16/2012(UTC) Posts: 3,806 Was thanked: 7 time(s) in 7 post(s)		Next time it happens, switch to spin in delicate cycle so that slow speed is selected versus fast speed. If it works ok in slow speed but cuts off/on in fast speed, problem is likely the speed switch. Speed switch is bypassed during the 2 minute drain. Eric


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest (3)

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close