Built 2007

Fridge couldn't hold temp, clicking noise from rear, hot, non-functioning compressor. Overload relay rattled when shaken, condenser fan barely spinning.

Control Board had 13.6VDC on J2 3,8 and 4VDC on J2 3,5 (condenser fan motor). No burn marks on control board or resistors.

So far I've installed a new overload relay (WR07X10097) and condenser fan (WR84X10055), fan still barely spins. Fridge has been working like a champ for several days with an aux fan blowing on the rear coils.

I unplugged it and left the doors open for a few minutes, then plugged back in. The compressor starts right up but the condenser fan barely spins and still just 4VDC on J2 3,5.

Am planning on replacing control board (WR55X10942) next to try and get the condenser fan spinning. What do you folks think? Test the new fan with a meter and/or battery first?

Thanks for the great forum, it's been a huge help