Kenmore washer won't fill and agitates at beginning of cycle - Appliance Repair Forum

Welcome Guest! You can not login or register.

Notification

Error

Kenmore washer won't fill and agitates at beginning of cycle Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: 110.29012990	Brand: Kenmore	Age: More than 10 years
Previous Topic Next Topic

glockej		#1 Posted : Friday, December 6, 2013 4:44:09 AM(UTC)
Rank: Member Groups: Registered Joined: 12/6/2013(UTC) Posts: 3		My washer stopped spinning during the rinse cycle a couple of days ago and after replacing the motor coupler the problem was resolved. After a test run I moved the washer back into its permanent place and now at the beginning of any cycle it starts to agitate immediately and doesn't fill with water. After doing some research it seems that it could be a timer issue but considering the price I want to be 100% sure before putting more money into this machine. Any assistance would be appreciated.


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

fairbank56		#2 Posted : Friday, December 6, 2013 4:54:55 AM(UTC)
Rank: Advanced Member Groups: Expert Joined: 10/16/2012(UTC) Posts: 3,806 Was thanked: 7 time(s) in 7 post(s)		Do you have the model number correct? That shows up as a commercial coin-op washer. Eric


User Profile View All Posts by User View Thanks

glockej		#3 Posted : Friday, December 6, 2013 4:57:49 AM(UTC)
Rank: Member Groups: Registered Joined: 12/6/2013(UTC) Posts: 3		Oops. It's 110.20912990


User Profile View All Posts by User View Thanks

fairbank56		#4 Posted : Friday, December 6, 2013 5:07:26 AM(UTC)
Rank: Advanced Member Groups: Expert Joined: 10/16/2012(UTC) Posts: 3,806 Was thanked: 7 time(s) in 7 post(s)		Open the control panel and disconnect the wiring plug on the water level pressure switch on the left side. If it still starts agitating right away, the timer is defective. If not, unplug the pressure hose from the switch, plug wiring connector back in. If it starts agitating right away, the switch is bad. If it's ok, blow through the hose to see if it's clear. Eric


User Profile View All Posts by User View Thanks

glockej		#5 Posted : Saturday, December 7, 2013 7:08:04 AM(UTC)
Rank: Member Groups: Registered Joined: 12/6/2013(UTC) Posts: 3		Once the water level switch is disconnected it does nothing when I turn it on. No water, no agitator. Sounds like it's a bad timer then, right?


User Profile View All Posts by User View Thanks

fairbank56		#6 Posted : Saturday, December 7, 2013 8:52:29 AM(UTC)
Rank: Advanced Member Groups: Expert Joined: 10/16/2012(UTC) Posts: 3,806 Was thanked: 7 time(s) in 7 post(s)		No, you didn't follow my directions, read my post again. Eric


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest (4)

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close