Customer Support 7 days a week

Welcome Guest! To enable all features please Login or Register.



New Topic Post Reply
Go to last post Go to first unread
#1 Posted : Thursday, October 17, 2013 5:20:51 AM(UTC)

Rank: Member

Groups: Registered
Joined: 10/17/2013(UTC)
Posts: 1

My Maytag Neptune front load washer will not fill with water. I see an error code "nd" on the display. The instruction service sheet, that is inside the console, says that this means no drain. Everything I look-up asks me to check the pump for blockage. I did this and cannot find any blockage. I checked the continuity of the water valve solenoids and they all test OK. If I manually fill the washer with water the pump empties the tub at the appropriate time. So as best as I can tell the pump is functioning fine. At this point I have no clue how to proceed. Are there any sensors that could be bad that might need to be replaced. Please help.
See inside of your appliance - diagrams and part photos for virtually every model.

powered by
#2 Posted : Thursday, October 17, 2013 3:20:44 PM(UTC)

Rank: Advanced Member

Groups: Senior Expert
Joined: 3/29/2009(UTC)
Posts: 11,699

The problem could be in the control board or in the pressure switch , and you may want to start by replacing the pressure switch on spec. If you order from this site and that is not the part that fixes it you can replace it.

You should also download the service manual for the Neptune 3000. You should be able to find a free download on the net, look for the one with the lonesome repairman on the front. Your model is covered in the back, even though that is not noted in the table of contents.

The manual will take you through a whole bunch of diagnostic testing you can do with this model.
Quick Reply Show Quick Reply
Users browsing this topic
Similar Topics
washer wont fill with water (Washer Repair)
by amtracker 6/16/2012 6:24:53 PM(UTC)
washer wont fill with water (Washer Repair)
by ron2011 10/16/2011 6:49:30 PM(UTC)
Maytag washer wont fill with water (Washer Repair)
by volguy 6/14/2009 6:33:24 PM(UTC)
Whirlpool washer wont fill with water. (Washer Repair)
by dfwhip 12/10/2007 8:03:07 AM(UTC)
New Topic Post Reply
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.