Rank: Member
Groups: Registered
Joined: 5/5/2008(UTC) Posts: 3
|
Hi, I just installed a 3-in1 start kit. Unit ran for a few minutes :), then I unplugged to make final connections. Now there is no power to the compressor :mad: . The lights inside come on, and I get power to the temp control. Any ideas?? If anyone could provide a wiring diagram would help out tremendously!
Thanks in advance!!
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC) Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
The 3 n 1 probably blew open the compressor windings, if you have a meter, check windings.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 2/29/2008(UTC) Posts: 19,638
Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)
|
Are the fans running? If not you may be in a defrost cycle. Should come out of defrost in about half an hour. |
THIS FORUM IS DEAD!!!!!!! |
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close