Rank: Member
Groups: Registered
Joined: 3/7/2013(UTC)
Posts: 9
|
Realized my problem testing at the switch. 129.4 between red and yellow at the switch.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Expert
Joined: 10/16/2012(UTC)
Posts: 3,806
Was thanked: 7 time(s) in 7 post(s)
|
You should have power across the wht/blk and blu wires at the same time that you have power across the red and yel wires. Seems your only getting power to the start winding and none to the high speed run winding. You should not allow this for longer than a couple seconds. The start winding and capacitor are only designed for intermittent power during the second or two that it takes for the motor to get up to speed. Once up to speed, the start circuit is opened by the centrifugal motor switch. Sounds like you have a bad control board if no power across wht/blk and blu.
Eric
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 3/7/2013(UTC)
Posts: 9
|
Any other way for me to confirm this? That is an expensive part so I may just have to get a new washer.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Expert
Joined: 10/16/2012(UTC)
Posts: 3,806
Was thanked: 7 time(s) in 7 post(s)
|
Check continuity between control board P7 (4 wires) and the motor connector and the blue wire on P9 and the motor connector.
Eric
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 3/7/2013(UTC)
Posts: 9
|
Got continuity everywhere I should there. Sounds like I am on the look for a new washer. I really appreciate all of your time helping me with this Eric. Thank you!
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
