Dishwasher will not get hot - Appliance Repair Forum - Free Service from Appliance Parts Pros

Welcome Guest! You can not login or register.

Notification

Error

Dishwasher will not get hot Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: QUIET PARTNER1	Brand: Whirlpool	Age: 1 - 5 years
Previous Topic Next Topic

Mickdog		#1 Posted : Saturday, January 26, 2013 7:04:31 AM(UTC)
Rank: Member Groups: Registered Joined: 1/26/2013(UTC) Posts: 2		I have a whirlpool quite partner 1 that is only 2 yrs old. The heating element in bottom of washer broke in half and I replaced this with a new one. Since it has been replaced it seems not to heat or dry dishes. It's like it will not get hot it want even clean the dishwasher itself any advice on what else could be wrong ? It's not like its rocket science to put an element in what else could be the issue


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

denman		#2 Posted : Saturday, January 26, 2013 9:06:00 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 2/29/2008(UTC) Posts: 19,638 Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)		A model number may help others help you. Find your model number - AppliancePartsPros.com
		THIS FORUM IS DEAD!!!!!!!


User Profile View All Posts by User View Thanks

Mickdog		#3 Posted : Saturday, January 26, 2013 10:12:55 AM(UTC)
Rank: Member Groups: Registered Joined: 1/26/2013(UTC) Posts: 2		Model #. Du1015xtxbi hope this will be helpful


User Profile View All Posts by User View Thanks

denman		#4 Posted : Sunday, January 27, 2013 12:18:58 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 2/29/2008(UTC) Posts: 19,638 Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)		Here are your parts Parts for Whirlpool DU1015XTXB1 Dishwasher - AppliancePartsPros.com See the attachment for the tech sheet. It could be the hi-limit thermostat. Remove power from the unit and one wire at the hi-limit thermostat (item 14 in the Tub and Frame section). Then check it with a meter should be 0 ohms. If OK Check the heater resistance, should be around 20 ohms. According to the sheet it has a large variance. If OK Check from P4-3 to P4-4 at the control board. Should be the heater resistance. If OK check the thermistor (item 23 in the Pump and Motor section) for resistance, see the tech sheet. If all the above are OK you probably need a new control board. File Attachment(s): DU1015.pdf (1,160kb) downloaded 2 time(s).
		THIS FORUM IS DEAD!!!!!!!


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest (2)

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close