AppliancePartsPros.com
»
Appliance Repair Help
»
Dishwasher Repair
»
Kenmore Dishwasher runs cycle, but will not start again
Rank: Member
Groups: Registered
Joined: 1/18/2013(UTC) Posts: 2
|
I have a Kenmore Dishwasher, Model 587.15193401. It will run a complete cycle, but I have to trip the breaker to get it to run again.
The clean and sanitize lights stay on even after opening the door. I have run test cycles, runs OK, but have to flip breaker at the box to get it to run again?
Checked door switches, OK, cleaned vent door, OK. Took board out and put back in. The dishwasher runs fine, but have to kill the power to get it to run each time????
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 1/18/2013(UTC) Posts: 2
|
Is there a way to check the board?
Thanks, Duane
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Hi Duane,
Frigidaire did not provide such information.
Gene.
|
|
|
|
AppliancePartsPros.com
»
Appliance Repair Help
»
Dishwasher Repair
»
Kenmore Dishwasher runs cycle, but will not start again
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close