Rank: Member
Groups: Registered
Joined: 9/21/2009(UTC)
Posts: 55
|
Hello guys this fridge is just past warranty, appliance outlet sent out sub-contractors on 3-4 occasions they all replaced defrost control board,heater and thermister every time and repair would last a couple of month's and evap. would freeze up again.I would like to know what the best way to put fridge into defrost manually? I ohmed out evap.motor at 200k got nothing 0 but it runs, also got ohms off the heater and thermister but dont have specs, any sugestions would be greatly appreciated. Thanks in advance! George
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 11/29/2007(UTC)
Posts: 16
|
According to Whirlpool, Unplug the refrigerator unit for about 30 seconds, and turn the thermostat located inside the refrigerator down to warm or off. <li class="step "> Reconnect the refrigerator to the wall. The adaptive defrost control should turn on in less than 10 seconds, and stay in defrost for about 20 minutes
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
