Roper washer tub badly out of alignment. Checked suspension springs and they were all there. Balance spring had fallen off, replaced but no help. You can move the tub into position by hand but it immediately falls out of alignment again. Suggestions?

tub support has collapsed through where suspension goes , new tub supprt is needed

The rear spring that runs between the tub support and the bottom frame has broken, The front panel does NOT come off your washer, The COMPLETE CABINET comes off in 1 piece, Remove the 2 screws at the rear corners of the console, slide the console ahead 1" and rotate it ovwr backwards, remove the 3 wire plug that is just rt of center at the rear of the washer top, take a flat blade screwdriver and pop the 2 GOLD colored clips off.(put the driver into the slot and push backwards to pop the clips) Pull the ENTIRE cabinet off paying attention to where the bottom of the cabinet lines up with the frame.(2tabs in front,2 tabs at rear corners) With it removed, look at the REAR on the left side and you will find a 6" long broken spring!!!!!