Installation of user interface AP3085303? - Appliance Repair Forum

Welcome Guest! You can not login or register.

Notification

Error

Installation of user interface AP3085303? Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: KUDS01FLSS6	Brand: Kitchen Aid	Age: 5 - 10 years
Previous Topic Next Topic

rusbet		#1 Posted : Wednesday, December 14, 2011 4:28:50 PM(UTC)
Rank: Member Groups: Registered Joined: 4/20/2009(UTC) Posts: 4		Would someone be willing to provide step by step instructions on how to replace the user interface on my Kitchenaid dishwasher? Please.


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

denman		#2 Posted : Friday, December 16, 2011 1:27:18 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 2/29/2008(UTC) Posts: 19,638 Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)		Here are your parts Replacement parts for WHIRLPOOL KUDS01FLSS6 UNDERCOUNTER DISHWASHER \| AppliancePartsPros.com Click on the picture of the part and a new page will open with Q&A help. The following should also help. KitchenAid KD-01 Stainless Steel Dishwasher Service Manual - ApplianceDigest.com You have to join the site to download the manual but it is free and this is a very good site for manuals and other info for the appliance repair DIYer.
		THIS FORUM IS DEAD!!!!!!!


User Profile View All Posts by User View Thanks

rusbet		#3 Posted : Friday, December 16, 2011 7:44:29 AM(UTC)
Rank: Member Groups: Registered Joined: 4/20/2009(UTC) Posts: 4		Yes, thanks for the link. We had purchased the user interface a few days ago from this site and it was delivered in a couple of days. A few minutes ago we removed all the screws from the door except the two near the bottom. The user interface was easily removed with some pressure on the tab holding it in place and lifting it at the same time using two flat head screw drivers. The ribbon/pin part was then detached with a little back and forth motion. Then the new interface was attached to the ribbon/pin part and inserted. Screws were put back in the door, breaker was switched to the "on" position. Dishwasher works. Thank you!


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close