Oven broiler and burner out - Appliance Repair Forum - Free Service from Appliance Parts Pros

Welcome Guest! You can not login or register.

Notification

Error

Oven broiler and burner out Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: 790.79383400	Brand: Kenmore	Age: 1 - 5 years
Previous Topic Next Topic

Amoncrieff		#1 Posted : Wednesday, October 29, 2008 4:03:55 PM(UTC)
Rank: Member Groups: Registered Joined: 10/29/2008(UTC) Posts: 3		I own a Kenmore elite duel fuel oven. The control panel works fine with no error messages. Gas top works fine. The electric warmer drawer also works fine. The electric broiler and oven burner are both not working. There appear to be no burn marks or other "cosmetic" defects on the broiler or over burner. I have not removed these yet. Could both be out at the same time? If it is just the elements, I can replace these, but for both to be out at the same time is to much for the layperson. Could it be something more that I should call a repair specialist? Thanks for any advice.


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

Gene		#2 Posted : Thursday, October 30, 2008 3:52:28 PM(UTC)
Rank: Advanced Member Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455 Was thanked: 4 time(s) in 4 post(s)		I could not find the wiring diagram for this range and I could not verify if there is a thermal cut-off or not. Look for the tech sheets on the back of the range or inside the control panel. If you'll find it then post it here. If there is a thermal protector then this part is bad. If there is no a such part then the problem is a bad control board. Gene.


User Profile View All Posts by User View Thanks

Amoncrieff		#3 Posted : Thursday, October 30, 2008 7:35:42 PM(UTC)
Rank: Member Groups: Registered Joined: 10/29/2008(UTC) Posts: 3		There is a " thermal block"in the wiring diagram. I'll try to upload the schematic tomorrow. Thanks, Amoncrieff Tried to upload the schematic but the file is too large. When I adjust the size, you can no longer read. Anywhere else I can upload the picture ? Amoncrieff


User Profile View All Posts by User View Thanks

Amoncrieff		#4 Posted : Monday, November 3, 2008 11:43:37 AM(UTC)
Rank: Member Groups: Registered Joined: 10/29/2008(UTC) Posts: 3		It was the control board. Thanks for the prior input and if anyone has a similiar problem, I hope this helps. Amoncrieff


User Profile View All Posts by User View Thanks

Gene		#5 Posted : Monday, November 3, 2008 2:34:20 PM(UTC)
Rank: Advanced Member Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455 Was thanked: 4 time(s) in 4 post(s)		We are glad you were able to fix it. Gene.


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest (3)

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close