Rank: Member
Groups: Registered
Joined: 10/23/2008(UTC)
Posts: 3
|
I am trying to replace the control switch on my dual element ceramic burner but the instructions do not match my configuration. Here are the details:
OLD SWITCH: (wire labels)
#1 Red (A/B)
#2 Black (RL1)
#3 Red (LF3)
#4 Brown (LFN)
#5 Red (RL2)
#6 Orange (LFA)
NEW SWITCH: [conversion instructions]
P1 [connect to 2]
4 [connect to 3]
4a [connect to 4]
S2 [connect to 5]
2 [connect to N or (L2b)N]
P2 [connect to N or (L2b)N]
Can anyone tell me how to connect this new switch? Thank you for your help.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 8/13/2008(UTC)
Posts: 3,097
|
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 10/23/2008(UTC)
Posts: 3
|
I have that instruction page but I have terminals #1 & #6, not N or (L2b)N. If I connect wires #2-#5 as per the instructions I have a red and orange wire left over not a red and brown.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 10/23/2008(UTC)
Posts: 3
|
OK, I goofed. After taking the switch completely out and examining it thoroughly in good lighting, I found that terminals 1 & 6 were actually not there and there was an N that I did not see. The switch is installed and working properly.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 8/13/2008(UTC)
Posts: 3,097
|
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
