Gene,

Please clarify how to reach this part. Is the part accessible through the wash tub or through the rear by pulling the unit away from the wall?

Don

GSD5950DOCC

I removed the screen from the bottom of the tub but found a fitting with a smooth bottom and an outlet 90 degrees on the side toward the door.

I had expected the plunger to be at the bottom of the fitting.

Problem i am having is the tub is not fully draining at the end of the last rinse cycle.

Don

Hi Gene,
Thank you for the clarification. I had removed parts 508 and 509expecting the part to be there and not in the back of the tub under part 543.

Don Worsham

I have the same type problem. The drain pump does not come on at all. Took it all apart Sunday afternoon, actually took pump out, hooked it up to power supply and it pumps water just fine. However, when installed it never comes on. The control panel is new, unit got hit by lightning and it fried control board. Replaced that and cycle selection and all works, main pump, vent, water supply, heater elements, etc. all work but drain pump will never come on. Any ideas what could be wrong?? I have heard some ideas about a turbidity sensor and flood asm switch, but do either of these interfere with command to start the pump??

Thanks much in advance!!
Joe

PS. my model is GSD6200J00BB

Thanks Gene,

I will try that, I was wondering if the new board was not working...finding an unplugged wire would be nice :-) BTW, I put 120vac into the pump and it worked just fine outside of the dishwasher, put it back into the D/W and no drain :-( Thanks again!

Joe