MKW,

It sounds like the optic boards are working,(could be working but not transferring circuit to ice maker).

Are you sure the system is ON, check the switch on the reciever board(right side of compartment wall).

As for the auger motor, you say you can hear it turn but nothing comes out,

Make sure the door bucket is properly seated and locked in place on the door dispenser assembly.

You may have stripped or broke the spring loaded drive gear or shaft.

You may also have a bad fill valve or loose connection

Here are the possible part numbers as you requested:

Part number: AP3137510

MKW,

My jumper ends were longer, more like 3/4", and it was a single strand, 12 guage wire. (from my brother the electrician).

Remember, once that large gear starts to move, remove the jumper wire.

Something else to try :

Remove the reciever board assembly(right side wall).

Disconnect the wire harness, and turn the power off.

(you'll need another jumper wire).
on the harness connector, with the jumper wire across pin#3 (black) and pin #4(black/white) turn the power on and then do the H to T test again.

If the icemaker works, you've got a communicaion error and need the board kit.

If the ice maker does not work, You've got a bad icemaker or broken wire, as long as you're sure your touching the internal contacts on T and H.

Hope this helps more.

:cool: :cool: :cool: