Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error

Options
Go to last post Go to first unread
bh77521  
#1 Posted : Saturday, September 8, 2007 5:30:11 PM(UTC)
bh77521

Rank: Member

Groups: Registered
Joined: 9/8/2007(UTC)
Posts: 1

I have a kenmore that was installed new when we bought the house 7 yrs ago.
During the fill cycle water comes in through the spray arm but when it goes to the wash and rinse cycle there is not enough pressure to spin the arm.
Is water supposed to come in somewhere else as well or do I have a pump problem

by the way the motor runs fine, house was built in 1961 and has galvanized pipe
is there a screen somewhere?

Thanks for the help
Bill
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com
 
Gene  
#2 Posted : Thursday, September 13, 2007 8:30:06 PM(UTC)
Gene

Rank: Advanced Member

Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455

Was thanked: 4 time(s) in 4 post(s)
Hi bh77521

Water comes into the dishwasher not through the spray arm.
It comes through the water inlet valve out of the hole on the left side of the tub.
The lack of the pressure could be if it is not enough water came into the dishwasher during the fill up time.
Add a 1/2 of gallon of water manually and see how the spray arm spins. If it spins better then the next step is to check the water shut off valve under the sink. Is it open all the way or not?
If it's fine then the problem is the water inlet valve. It could be blocked with hard water deposits or it's not opening all the way. In both cases it has to be replaced.

- The part number for the new water inlet valve AP3010773

Good luck.
Gene.
richappy  
#3 Posted : Friday, September 14, 2007 2:03:36 AM(UTC)
richappy

Rank: Advanced Member

Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586

Was thanked: 2 time(s) in 2 post(s)
Start your dishwasher in fill mode and count the seconds for fill by listening to the water flow. If it fills for more then 40 seconds, but the tub is not filled to near the heater, you have a partially blocked screen in water valve, or low water pressure to it or just a bad valve. If it fills for much less than 40 seconds, you have a bad timer.
Users browsing this topic
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.