Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error
No Power to fill valve
Options
Go to last post Go to first unread
Model: KUDJ230YWH0 Brand: Kitchen Aid Age: More than 10 years
Previous Topic Next Topic
dpk1000  
#1 Posted : Wednesday, September 12, 2007 4:34:21 PM(UTC)
dpk1000

Rank: Member

Groups: Registered
Joined: 9/12/2007(UTC)
Posts: 3
Alll of a sudden, the dishwasher would not fill up with water.

I tested the old fill valve and found it to be operational when AC is applied.

I used the documentation to determine that there is NO power to the fill valve under any circumstances.

Ideas ??

PS: It occured to me that the onset of this problem was accompanied by the strong smell of something 'burning up' underneath the machine.

Thanks !!!
Back to top
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com 		 
Back to top  
richappy  
#2 Posted : Wednesday, September 12, 2007 5:55:16 PM(UTC)
richappy

Rank: Advanced Member

Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586

Was thanked: 2 time(s) in 2 post(s)
The ground to the fill valve is daisy chained together with a lot of things like the heater. Look around under the washer and look for a burnt/loose connection.
If ok, you should pull front panel and find the timer terminal that supplies voltage to the fill valve. Sometimes the pin gets burnt or pulls out a little, just push it in with meter probe. I check with the washer running, but with the motor wires disconnected to avoid spray arm spray!! If ok probably a stuck float.
Back to top
dpk1000  
#3 Posted : Thursday, September 13, 2007 6:57:45 PM(UTC)
dpk1000

Rank: Member

Groups: Registered
Joined: 9/12/2007(UTC)
Posts: 3
Here is one for the books: The blue wire that feeds the fill valve broke and burned through the insulation where the entire group of wires passes through a metal guide at the bottom of the door. Almost impossible to detect without my magnifier. Tomorrow, I'll pick up some wire of the correct gauge, splice in a piece and re-do the protective layer of tape. Done !!!

Thanks for your help !!!
Back to top
Users browsing this topic
Guest (2)
Similar Topics
no power to fill valve (Dishwasher Repair)
by jholovich 6/21/2010 10:10:04 AM(UTC)
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Privacy Policy | Powered by YAF.NET | YAF.NET © 2003-2024, Yet Another Forum.NET