Rank: Member
Groups: Registered
Joined: 2/25/2010(UTC) Posts: 1
|
Have taken the front panel off, cleaned out the lint, checked the connections. Ignitor glows red, and sometimes will get a flame, but after a few minutes the flame goes out. After a couple of minutes, the ignitor glows red again (making a clicking noise), but there is no flame. When I do get a flame, the dryer does heat. The timer advances.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 8/16/2007(UTC) Posts: 3,273
|
The ignitor should glow bright orange. If you're getting only a red glow, you should replace the ignitor Part number: AP4047655
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close