Rank: Member
Groups: Registered
Joined: 3/23/2008(UTC)
Posts: 1
|
Replaced the Ice maker (hole unit) over the weekend, and the new Ice Maker only dumps ice about every 4 - 5 hours. Is there a way to adjust the Frenquency?
Freezer temp is 1 degree.
On the original unit; the non stick liner in the mold started to peel and the liner was freezing in the ice. When the heater unit came on the ice would melt from the mold but the liner was frozen into the qubes causing them to stick and the ejector would hang up. Figured I would replace the complete unit. Simple way out!
After cutting all the loose liner out with a box knife I put the old ice maker back in and it dumps about every hour.
Any suggestions?
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
The ice maker has built in thermostat which reads the ice maker temperature and operates with the head module. If the ice maker is not cold enough, it will take much longer time between cycles.
If the new ice maker was there for more then 24 hrs, possible the thermostat is defective. In that case you have to call the customer service to exchange the ice maker under the part warranty.
Gene.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
