Rank: Member
Groups: Registered
Joined: 3/6/2008(UTC)
Posts: 2
|
I need to replace the compressor in my Whirlpool side by side. It's DOA pulls 18 amps with a clamp on amp meter when it trys to start. Locked rotr is 20A.The replacment assembly would be 8201558(Whirlpool 2183455). The assembly includes a copper dryer unit. Is that only used for installation instead of a Schrader valve? Is the dryer unit used to insure that mositure content is to spec for a new installation or during operation of the new compressor? How much 134A will it take to install the new unit? Does anybody have a step by installation guide? I have access to a vacumn unit and pressure gages.
thanks,
John C
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
You may just need a new start relay, just order the factory replacement. Compressor replacement for the " average person" is to be avoided if possible. I try to avoid it myself, too many things may go wrong.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Expert
Joined: 2/16/2008(UTC)
Posts: 79
|
if you have never done it, don't.... at least unless you are ready to still buy a new refrig after you're done and it still doesn't work. no offense, but this is difficult for pro's. you have to be pretty damn good with a torch to do it and not melt everything around it.
good luck...
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 3/6/2008(UTC)
Posts: 2
|
The starter was a piece of charcoal. Did try a different one almost fried that one too. Is the coppper dryer tube in the assembly photo also an access valve?
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Hi John,
In addition to Rich's and Roy's recommendations I want you to know that
it is illegal to handle refrigerants without EPA certification. Violation of this law subject to fine and could be as much as $27,500
Gene.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
Uh, Gene, don't think there is any restriction for handling R134A and I'm sure he has R134A in his fridge. It might require a certificate to buy it though. High fines are only for hydrocarbons like R22, R11, R12 etc.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
