Lots of water spraying from arms, but they don't spin - Appliance Repair Forum

Welcome Guest! You can not login or register.

Notification

Error

Lots of water spraying from arms, but they don't spin Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: MDB8600AWB	Brand: Maytag	Age: 1 - 5 years
Previous Topic Next Topic

rjs.napc		#1 Posted : Tuesday, December 1, 2009 5:30:42 PM(UTC)
Rank: Member Groups: Registered Joined: 12/1/2009(UTC) Posts: 2		The water level is at about the heater element, lots of water comes out of the arms, but they don't rotate. I've checked the impeller and cleaned the bottom of the unit. No obstructions. I don't see any scale anywhere. What next? Is the pump the likely culprit?


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

denman		#2 Posted : Wednesday, December 2, 2009 1:19:11 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 2/29/2008(UTC) Posts: 19,638 Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)		Here are your parts Replacement parts for MAYTAG MDB8600AWB Dishwasher - Undercounter \| AppliancePartsPros.com Here is a tech sheet http://www.servicematters.com/m...ibrary/docs/16023220.pdf Here is a manual http://www.servicematters.com/m...ibrary/docs/16021814.pdf Check that the arms rotate freely. Check that the angled holes in the spray arms are clean. Check that none of the arms have split. Check that the flappers in the rear water distribution channel are OK. Could be that the water is gushing out of one of these instead of going to the spray arms. Check the over pressure filter clipped to the side of the rear water distribution channel is OK. Check the water level most units fill to just below the heater element. Note some units fill to just over the heating element, I am not sure about this unit. Try adding a couple quarts of hot water after a fii, if it nor sprays correctly then odds are the inlet screen filter on the water valve is partially clogged.
		THIS FORUM IS DEAD!!!!!!!


User Profile View All Posts by User View Thanks

rjs.napc		#3 Posted : Wednesday, December 2, 2009 6:03:00 PM(UTC)
Rank: Member Groups: Registered Joined: 12/1/2009(UTC) Posts: 2		Checked all that, again. Water level is fine. Any higher, and it'd leak. No cracks or splits, no plugged holes. Flappers are new and functioning. Over pressure filter is clean. Soooo. Pump? Thanks for your help.


User Profile View All Posts by User View Thanks

denman		#4 Posted : Wednesday, December 2, 2009 11:54:38 PM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 2/29/2008(UTC) Posts: 19,638 Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)		You have checked everything, at least everything that I can think of. All that is left is the pump. Pull it and take it apart. Hopefully something will show up.
		THIS FORUM IS DEAD!!!!!!!


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest (5)

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close