Post a reply - Appliance Repair Forum - Free Service from Appliance Parts Pros

Last 10 Posts (In reverse order)
denman	Posted: Sunday, March 3, 2013 1:07:29 AM(UTC)
	I do not know what happened with the tech sheet so here is another try at attaching it.
	THIS FORUM IS DEAD!!!!!!!
swallen	Posted: Saturday, March 2, 2013 2:07:16 PM(UTC)
	Thank you for your help Denman. The PDF wouldn't open but I will check out the control board. That is what we expected.
denman	Posted: Saturday, March 2, 2013 4:40:26 AM(UTC)
	Here are your parts Parts for Whirlpool KUDS03FTSS2 Dishwasher - AppliancePartsPros.com See the attachment for the tech sheet. I am assuming that everything looks normal after a cycle other than you cannot start another cycle. Look through the tech sheet in case anything listed there comes up. if all OK I would replace the control board (item 6 in Control Panel Parts section)
	THIS FORUM IS DEAD!!!!!!!
swallen	Posted: Friday, March 1, 2013 1:48:52 PM(UTC)
	Sorry, the model is KUDSO3FTSS2
denman	Posted: Friday, March 1, 2013 7:36:02 AM(UTC)
	Already tried a zero.
	THIS FORUM IS DEAD!!!!!!!
swallen	Posted: Friday, March 1, 2013 2:45:26 AM(UTC)
	That may be a zero instead of an O on the model number. If it is the control board does that mean we would have to replace the whole board and what would be the cost?
denman	Posted: Friday, March 1, 2013 2:22:26 AM(UTC)
	I cannot find any info on the given model number. Tried here and the Whirlpool site. Please check it. Sounds like a control board problem. The4 microprocessor is not resetting by itself but when you remove power from the unit then you manually reset it.
	THIS FORUM IS DEAD!!!!!!!
swallen	Posted: Thursday, February 28, 2013 5:08:03 PM(UTC)
	Lights on the panel come on but the dishwasher will not start. If we flip the circuit breaker it will start even though the breaker was not off.

Notification