|
Ok for the real quick reply, I'll check both, i'll get back to it next week..
thanks
fran
|
|
i would check the vent first to make sure its clean if dirty will cause it to short cycle,if thats not it check the solenoids on top of gas valve
|
|
Your wiring diagram should be in your control panel. Nat
|
|
This dryer, will light up but a few seconds later the flame goes out. I am not sure just where to start. Where might i be able to get a schematic, I can follow one. can someone head me in the right direction? thanks fran
I hate to say this but I repair commercial machines, but these 'home' type can get confusing.
wait, i just found the parts diagram...
|