Rank: Member
Groups: Registered
Joined: 3/18/2009(UTC) Posts: 1
|
I have a Maytag Neptune MAH 5500BWW. Works fine until about 9 shows on the display, then displays zero and leaves water in machine. I have had service techs look at it and have replaced the door latch switch and wiring harness. Runs a service cycle with no error codes and completely dry. Problem has been intermitent over the last couple years now consistent. Any help diagnosing would be appreciated.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC) Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
You could have a cracked control board behind the console or an intermittant connector. I use a non-residue cleaning spray and disconnect connectors and spray them.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close