Rank: Member
Groups: Registered
Joined: 3/27/2024(UTC) Posts: 0 
|
I was replacing the heating element on my Kenmore 100 dryer. All went well, but then i accidentally touched something (not sure what exactly) in the area of the element with one of my tools. It created a spark, and now the new element wont heat up. Any suggestions on what that spark might have burned out? I replaced the fuse already with no luck. thanks.
|
|
|
|
|
|
Rank: Guest
Groups: Joined: 8/10/2018(UTC) Posts: 0 Location: 99556 Was thanked: 4 time(s) in 4 post(s)
|
You may have caused the heating element wire to contact the metal support and damaged it to the point that it will continue to short out. Take it apart and check to see where it is contacting and see if it is only a temporary situation. Chances are the element will need to be replaced.
|
|
|
|
|
|
Rank: Member
Groups: Moderators, APP Team, Registered Joined: 2/27/2024(UTC) Posts: 0 Location: TN Was thanked: 5 time(s) in 5 post(s)
|
The element will certainly need to be checked for damage. Also, if the model number of your appliance could be provided, it may allow the most accurate information to be presented.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
