Rank: Member
Groups: Registered
Joined: 8/10/2009(UTC)
Posts: 2
|
My Superba Kitchenaid ice maker is making ice, but is not ejecting the ice. The plastic fingers rotate to the point where the ice is sitting on top of the ice chipper, but not falling to the ice bin. The optics of the ice maker work normally, (blink when door open, steady light when flapper is shut.). I am trying to determine if I need to order a thermostat, ice mold or new ice maker?
Thanks,
Dean
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 3/28/2009(UTC)
Posts: 1,648
|
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 8/10/2009(UTC)
Posts: 2
|
Repairman,
Thanks for the advice and referencing the repair guide. I will follow the repair guide recommendation and test to see if the module or thermostat need replacing.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Originally Posted by: 38dean  Repairman,
Thanks for the advice and referencing the repair guide. I will follow the repair guide recommendation and test to see if the module or thermostat need replacing. Keep in mind - there is relatively low success rate on ice makers repair. Very often it is more cost efficient and much more reliable to replace the whole ice maker. - The ice maker Part number: AP3182733
Gene.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
