Post a reply - Appliance Repair Forum - Free Service from Appliance Parts Pros

Last 10 Posts (In reverse order)
richappy	Posted: Wednesday, April 2, 2014 8:05:27 AM(UTC)
	I know nothing about this .
jsstabby	Posted: Wednesday, April 2, 2014 7:35:46 AM(UTC)
	Sorry to be a bother, but one last thing. I have seen on a website that a new jumper harness is supposed to be installed when replacing the evap fan motor. Could this be the issue? If not, I will have my board rebuilt. Evaporator Fan Installation Kit For KSS, KSC, and other Whirlpool/KitchenAid/Kenmore/JennAir/Maytag Refrigerators « ApplianceBoards
richappy	Posted: Wednesday, April 2, 2014 7:21:32 AM(UTC)
	Your board must put a square wave out to run the motor, you have a bad board. Make sure the motor is new also.
jsstabby	Posted: Wednesday, April 2, 2014 5:55:56 AM(UTC)
	I found it. An article on ************************.com Defrost, Condenser, Temperature, or Other Problems in KSS, KSC and other Whirlpool/KitchenAid/Kenmore/JennAir/Maytag Refrigerators « ApplianceBoards Claims that this particular board (verified it is identical to mine) should have 11.5V or higher between pins 9 and 11 and the board is good. I have 11.68VDC, so my board should be good. I am also getting 11.68VDC to the fan motor. I replaced the evap fan motor, and my problem still exists. What else could be the problem? What are the chances the motor you sent me was also bad?
richappy	Posted: Tuesday, April 1, 2014 7:41:30 AM(UTC)
	Look at the break0own diagrams, I only see a big control board.
jsstabby	Posted: Tuesday, April 1, 2014 7:19:19 AM(UTC)
	Are you talking about the temperature control board? It is in the drop down control box. I am looking for the power control board that is supposed to be under the fridge liner, but I do not see anything that looks like a control case - just the inverter. Thanks for your response.
richappy	Posted: Tuesday, April 1, 2014 4:15:08 AM(UTC)
	It's behind the control panel in the fridg section.
jsstabby	Posted: Monday, March 31, 2014 9:54:52 AM(UTC)
	Our fridge doesn't cool. Compressor and condensor cooling fan are running OK. Evap fan won't run and fridge beeps every four seconds. Beeping stops when I disconnect evap fan motor. I have 12 volts to fan motor, checked when I unhook fan motor. Bi-metal and heating element have continuity. Replaced evap fan motor with new - get the same beeps and fan won't run. Next guess is, I have to have the control board rebuilt (W10219463). Core Centric Solutions says they can do it. I cannot find the control board! Everything says it is just to the left of the compressor, but all I find is the inverter. Do you have a picture or a video that shows the location of this control board? I cannot find it to remove it!

Notification